2 Display basics Powering on or off
Powering on or off
Note – The display must be correctly installed before powering on. For more information, see
Installation overview, 100 and TMX-2050 Display Cabling Guide.
Automatic power on
If the display is connected to the ignition source, power on the vehicle. The TM-200 Module sends
power to the display when the vehicle powers on.
Manual power on
To turn on the display manually, hold the power button down briefly (about half a second). For a
photo of the rear view showing the power button, see TMX-2050 display, 95.
The display powers on, and after a short pause the Home screen displays.
Automatic power off
If the display is connected to the ignition source, when you switch the ignition off, a
shutdown/reboot dialog displays. If you do nothing the display shuts off in 60 seconds. If you
choose not to shutdown the display, it will remain powered on indefinitely.
CAUTION – If you leave the display powered on after shutting off the vehicle's ignition, the display power can
drain the battery.
Manual power off
To manually turn the power off, hold the power down button for one to two seconds.See the steps
below.
1. Turn off the display manually by holding the power button down for about two seconds.
2. Choose one of the following options:
ll Shutdown:Powers down the display
l Reboot:Restarts the display
l Cancel: Cancels the power off process
Note – Sometimes after you press the power button and tap Shutdown, the display does not
immediately turnoff. This is because the display is saving settings. The display will power off after
all settings are saved.
If these steps do not cause the power to go off, you can force a shut down of the display by holding
the power button for 5 seconds.
40 TMX-2050 Display User Guide Version 1.075, Revision C
To Next Page
Loading...
