8 Implements Application control
Tap... To...
Material Controlled By View the current option (control the material using a switch box).
Boom to Application
Point or Toolbar to
Application Point
Enter this measurement only if the application point for this
channel is not the same as the application point that you used for
.
ll Measure from the application point used in the Implement
Measurements section to the point where this material is
applied.
l If the new application point is further back, enter a positive
value. If it is toward the front, enter a negative value.
Channel Name The system names the channel. You can optionally change the
name of the channel.
8. Tap Next to continue. The display goes to one of the following, depending on your
configuration:
a. Section control, 198.
b. Rate control, 202.
Section control
At the Settings section for section control setup:
1.
Tap next to Section Control to turn on this feature. This toggles section control on or
off for the current channel.
2.
Tap Control Type.
Tap... To...
Field-IQ individual
sections
Use Field-IQRate Control modules for Section Control. Continue to
the next step (3).
198 TMX-2050 Display User Guide Version 1.075, Revision C
To Next Page
Loading...
