9 Materials Calibrate material flow
3. Tap Assign Material on the right-hand side of the screen.
4.
Tap the material that you want to assign to the channel. The list shows only the materials that
are the same type as the control channel's Material Type.
If you have not set up the material that you want to assign, tap Material Library.
If a material is already assigned to the channel, the item in the list has a next to that
material.
Note – For the most accurate application, calibrate the flow. See Calibrate material flow, 230.
Calibrate material flow
For the most accurate application, calibrate the flow.
WARNING – Material will be dispensed during calibration. Make sure that the implement is safe to operate.
WARNING – During flow calibration, the machine will become operational. Take all necessary precautions to
ensure user safety. Failure to do so may result in serious injury or death.
Pre-calibration steps
Before you calibrate flow:
1. Complete the implement and rate control configuration and calibrations.
2. Select a control channel and assign a material. See Managing materials, 226.
Calibration steps
1.
At the Home screen, tap . The Material setup panel displays.
2.
Tap the channel name in the list on the left-hand side of the screen.
3. Tap Flow Calibration on the right-hand side of the screen.
4. Tap the drive you want to calibrate. The calibration tool displays.
5.
Review the settings and update if necessary.
Note – For information about the appropriate values for your sprayer, refer to the support
note Field-IQ crop Input Control System: For Sprayers and Spreaders.
230 TMX-2050 Display User Guide Version 1.075, Revision C
To Next Page
Loading...
