8 Implements Boom height control
4. Continue setting up each sensor.
5. Tap Next to go to Operation settings, 212.
For information on: See:
Control during operation
Boom height control operation, 276
Adjustment during
operation
Boom height adjustments, 278
Operation settings
At the OPERATION section of Boom Height settings, review the existing settings. Make changes to
the settings as required. Your options will depend on which option you chose for the Boom Control
Layout in the Control section. See Boom height control setup, 210 for more information.
WARNING – Working without a working SIMis dangerous.
Refer to the settings listed below to edit operation settings.
Note – The settings that display on your screen depend on the type of Boom Control Layout you
chose at the CONTROL section. (See Boom height control setup, 210.)
Tap... To...
Target Height
Enter the distance above the ground or crop canopy (see Sensing
Mode below) that you want the nozzles to be.
Minimum Target Height
Set the lowest value that the target height can be set to.
If a height sensor on a multi-sensor zone is reporting a height lower
than this value, the display will switch from using the average zone
height to using just the lowest sensor.
Maximum Target Height
Set the maximum height that the target can be.
System Aggressiveness Set the aggressiveness for the boom height control system. A higher
value is more aggressive, and a lower value is less aggressive.
Roll Stabilizer Raise this setting to increase the boom roll stability.
212 TMX-2050 Display User Guide Version 1.075, Revision C
To Next Page
Loading...
