Trimble TMX-2050 - Alarms; SIM

8 Implements Inputs
Tap Next to continue to Alarms.
Alarms
At the Alarm section, you can set up alarms for sensors.
1.
Turn on Alarms by tapping .
2. Change the settings as appropriate.
Tap... To...
Alarm Turn this feature on or off.
Warn If Below Enter the value that will trigger the alarm when the sensor reading is
below this value.
Warn if Above Enter the value that will trigger the alarm when the sensor reading is
above this value.
Warn After Adjust the number of seconds before the alarm triggers.
3.
Tap .The display saves your settings and returns to the Inputs section (see Inputs, 219).
4.
Tap to add another sensor.
5.
Tap Next to go to the SIM section (see .
Note – All pressure sensors must be calibrated. When you are ready to perform the
calibration, see Inputs / Sensors calibration, 221.
SIM
Note – If you are using Boom Height Control, a SIMis required.
If your system has a SIM, at the SIM section choose the type of sprayer. If your system does not
have a SIM, tap Next.
You may also choose to enable or disable boom height here.
1. For some self propelled sprayers that are using the SIM to control sections for Field-IQ on the
factory joystick or console, tap Application ControlFIQ and select the sprayer you are using.
2. If you need to disable the override feature on the booms, tap Boom Height and choose
disable. This will cause the joystick controls to no longer disengage automatic boom height
control.
3. Tap Next to continue to the Summary section.
220 TMX-2050 Display User Guide Version 1.075, Revision C