Field-IQ diagnostics 11 Diagnostics / troubleshooting
Latencies
Item Explanation
Apply Latency to
Boundary
Turn setting on or off by tapping. This setting applies to fields that have a
boundary, and when you exit an exclusion zone and return to the workable
area of the field.
l On: The system uses on latency to begin applying material immediately
when crossing a boundary.
l Off: The system starts when the boundary is reached and any mechanical
delay could leave a gap between the boundary and where the product is
applied. When GPS accuracy is low, this is the preferred selection.
On Latency
The length of time (seconds) from when a section is turned on to when the
system begins to apply material.
Sections Off When
Stopped
Turn setting on or off:
l On: The sections shut down when the vehicle is stopped.
l Off: The sections remain open (turned on) when the vehicle is stopped.
Off Latency The length of time (seconds) from when a section is turned off to when the
system stops applying material.
Hardware
Item Explanation
Controller Module type (such as master switchbox, section control module, and so on)
Module S/N Serial number of module
Position Position of module on channel
Version Firmware version of Field IQ module
Status Connected, disconnected
Sensor
Item Explanation
Channel
Name:Material
Name of channel
Module S/N Serial number of module
Version 1.075, Revision C TMX-2050 Display User Guide 313
To Next Page
Loading...
