Trimble TMX-2050 - Adjustments; Summary

Application control 8 Implements
1.
At the Virtual Tank section, tap next to Virtual Tank. This toggles the virtual tank On
and Off for the current channel.
2.
Tap each setting and then choose an option.
Tap... To...
Units
Select the units to use for tank volume (gallons/liters).
Full Capacity
Volume
Enter the tank's capacity.
Warning Type Choose how you want to trigger the low-volume alarm:
ll Volume: Alarm when volume dips below this level.
l %: Alarm when volume is less than this percent of capacity.
Warning Level
Enter the volume (amount or percent) below which you want to see an
alert.
3. Tap Next to continue to Adjustments, 207.
Adjustments
At the Adjustments section for application control, review and change the settings for the current
channel as required.
Tap... To...
Jump Start Speed Adjust the jump start speed. When the Field-IQsystem's Master switch is in
the jump start position, the system applies material at the rate for this speed
instead of the vehicle's current speed.
This manual override option can be used to operate the system when the
vehicle is stationary, or when GPS is unavailable.
Jump Start
Timeout
Adjust start timeout. This setting limits the length of time you can run the
jump start.
Note – Auto-control resumes if Jump Start Speed is exceeded by ground
Speed.
Shut Off Speed Adjust shut off speed. The system shuts down if the implement drops below
this speed.
When you have completed these settings, tap Next to continue to Summary, 207.
Summary
The Summary section shows an overview of all the settings for the channel.
Version 1.075, Revision C TMX-2050 Display User Guide 207