Trimble TMX-2050 - USB socket

2 Display basics USB socket
Type of transfer (without
Farm Works)
Instructions
USB
To transfer data through a USB drive, see From TMX-2050 display to
TMX-2050 display, 73 in this section.
Wireless (Office Sync)
To transfer data using Office Sync:
l Ensure you meet the requirements for transferring using Office
Sync. See From TMX-2050 display to TMX-2050 display, 73 in
this section.
l Set up Office Sync. See Modem services settings, 88.
USB socket
The display has two USBsockets: one on the side of the display and one on the back of the TMX-
2050 display. (See TMX-2050 display, 95 for photo showing the locations of the two USB sockets.)
You can use a USBdrive to transfer data to and from your TMX-2050 display.
CAUTION – Do not use a USB drive in each USB socket at the same time. If you are attempting to upgrade
firmware using a USB drive and another USB drive is already in one of the sockets, the firmware upgrade will
fail.
The display senses when a USB drive is inserted into either the side or rear socket, and shows the
icon on the display bar.
To use the USB drive:
1. Tap the bottom right corner of the display bar.
2.
When the notification list displays, tap . The USB menu displays.
3. At the USB menu, you can:
ll
Tap to display the data transfer panel. See Data transfer, 67.)
l
Tap to take a screen shot and store it on the USB drive. See Screen shots, 75.
l
Tap to upgrade firmware from the USB drive. See Firmware upgrades - wireless, 80.
74 TMX-2050 Display User Guide Version 1.075, Revision C