Calibrate material flow 9 Materials
Tap... To...
Target Rate Enter the rate to use for the calibration.
Speed Enter the test speed to use during calibration. The system will
apply material at the rate required to reach the Target Rate if the
vehicle was traveling at this speed.
WARNING – Moving parts during this operation. Make sure that the implement is safe to operate.
6.
Tap Run Calibration.
7. Follow the on-screen instructions to complete the flow calibration.
8.
To accept the new values, tap .
9. To use the new values but recalibrate with them, tap Recalibrate.
10.
To discard the new values and begin again, tap .
Version 1.075, Revision C TMX-2050 Display User Guide 231
To Next Page
Loading...
