3-110 Xerox Internal Use Only Phaser 6500/WorkCentre 6505 Service Manual
Error Messages and Codes
IOT Feeder Configuration Failure
Applicable Error Code
• 072-215
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Option Harness Assy
(PL3.1.20)
■ MCU Board (SFP PL8.2.13;
MFP PL8.3.6)
■ Optional Feeder (PL12.1.99)
■ Tray Harness Assy (PL12.3.23)
■ “Map 2 - SFP Laser Unit and Feeder” on
page 10-7
■ “Map 4 - SFP MCU Board” on page 10-9
■ “Map 5 - SFP Optional Feeder” on
page 10-10
■ “Map 6 - MFP Print Engine” on page 10-15
■ “Map 9 - MFP MCU Board and HVPS” on
page 10-18
■ “Map 10 - MFP Optional Feeder” on
page 10-19
■ “SFP Option Feeder” on page 10-35
■ “MFP Option Feeder” on page 10-50
Troubleshooting Procedure
Step Actions and Questions Yes No
1 Check the Optional Feeder for
installation.
Is the Optional Feeder installed
correctly?
Go to step 3. Reseat the
Optional
Feeder, then
go to step 2.
2 Does the error still occur when the
power is turned Off and On?
Go to step 3. Complete.
3 Check the connectors for connection.
Check the connections between the
Feeder Board and MCU Board.
Are P/J27, P/J273, and P/J419
connected surely?
Go to step 5. Reconnect the
connector(s) P/
J27, P/J273
and/or P/J419
surely, then go
to step 4.
4 Does the error still occur when the
power is turned Off and On?
Go to step 5. Complete.
5 Check the Tray Harness Assy for
continuity.
Disconnect P/J419 from the Feeder
Board.
Disconnect P/J273 from the Option
Harness Assy.
Is each cable of P/J419 <=> P/J273
continuous?
Go to step 6. Replace the
Tray Harness
Assy.
http://www.manuals4you.com
To Next Page
Loading...
Need help?
General
