Phaser 6500/WorkCentre 6505 Service Manual Xerox Internal Use Only 8-3
Service Parts Disassembly
Preparation
Before you begin any procedure:
Unplug the power cord from the wall outlet.
Allow the Fuser to cool before using the procedure.
Remove and cover the Imaging Unit to avoid light exposure.
Many parts are secured by plastic tabs. Do not over flex or force these parts.
Do not over torque screws threaded into plastic.
Names of parts that appear in the removal procedures may not match the
names that appear in the Parts List. For example, a part called Paper Tray in a
removal procedure may appear on the Parts List as Cassette, Assy.
While performing removal procedures, ignore any prerequisite procedures for
parts already removed.
1. Wear an Electrostatic Discharge wrist strap.
2. If the printer is operational, use the Printer Diagnostics routine “Save NVM to
ESS” on page 4-15 to transfer the contents of the MCU NVRAM to the IP
Board.
3. Turn Off power and disconnect the power cord from the wall outlet.
4. Disconnect all cables from the printer.
5. Remove these items:
a. Paper Tray
b. Imaging Unit (page 8-7).
c. Fuser (page 8-10).
d. Toner Cartridges (page 8-12).
The disassembly procedures include steps for the removal of these parts.
To Next Page
Loading...
Need help?
General