1-24 Xerox Internal Use Only Phaser 6500/WorkCentre 6505 Service Manual
General Information
First Print Output Time
First Print Output Time (FPOT) is defined as a time from when the engine receives
a Start signal in Ready state, until a single page is delivered to the output tray.
The following conditions are applied:
• The Controller does not keep the print engine waiting
• The printer is at Ready mode
• Paper is A size Short Edge Feed (SEF)
• Process control time is not included
Recording The system is at Pause.
Fusing The system is Off.
IIT The Scanner and ADF are off.
Cooling Fan The system is Off.
Control Panel
Operation
LCD: Off, LCD Backlight: Off
LED: Wake Up LED is On.
NOTE When the printer receives a print or Fax job or the Wake Up/Power Saver
button is pressed, the printer exits the Power Saver mode and enters the
Ready mode.
Mode Tray FPOT (sec.)
a
a. Maximum FPOT time is 18 seconds for mono or color. If the preceding job was all mono, and
the first page in the next job is mono, FPOT is 12 seconds. If the last job had any single color
page, and the first page in the next job is color, FPOT is 13 seconds. If the printer has to switch
modes, FPOT is 18 seconds.
Color Tray 13.0 sec. or less
Manual Feed 13.0 sec. or less
Mono Tray 12.0 sec. or less
Manual Feed 12.0 sec. or less
Mode Condition Description
http://www.manuals4you.com
To Next Page
Loading...
Need help?
General