6-6 Xerox Internal Use Only Phaser 6500/WorkCentre 6505 Service Manual
Adjustments and Calibrations
Calibrations
Initializing Print Meter
This process initializes the Print Meter.
1. On the Control Panel, press Menu.
2. Press the Up or Down arrow to find Admin Menu. Press the OK button.
3. Press the Up or Down arrow to find Maintenance Mode. Press OK.
4. Press the Up or Down arrow to find Init PrintMeter. Press OK.
5. Are you sure? message is displayed. Press OK to start the process.
6. Initialized message is displayed. The Maintenance Mode - Init PrintMeter
menu is displayed when the process is completed.
Initializing NVM (NVRAM)
This process initializes the settings stored in the NVRAM except for the network
settings. The NVRAM is a non-volatile memory that stores the printer settings even
after the power is turned Off. After executing this function and restarting the
printer, all the menu parameters are reset to their default values.
1. On the Control Panel, press Menu.
2. Press the Up or Down arrow to find Admin Menu. Press OK.
3. Press the Up or Down arrow to find Maintenance Mode. Press OK.
4. Press the Up or Down arrow to find Initialize NVM. Press OK.
5. Are you sure? message is displayed. Press OK to start the process.
6. Initializing... --> Initialized messages are displayed.
7. The Maintenance Mode - Initialize NVM menu appears when the process is
completed.
8. Turn the printer power Off and back On.
http://www.manuals4you.com
To Next Page
Loading...
Need help?
General