Xerox Phaser 6500 Service Manual

8-140 Xerox Internal Use Only Phaser 6500/WorkCentre 6505 Service Manual
Service Parts Disassembly
SFP IP Board Cage
This procedure removes the entire IP Board cage including the fan duct. Although
it is not associated with any one part, it simplifies other procedures.
Note
The “circled” screws in this procedure have a circle scribed in the chassis
around their locations.
1. Perform the service preparation steps on page 8-3.
2. Open the Front Cover.
3. Remove the Top Cover (page 8-15).
4. Remove the Right Side Cover (page 8-17).
5. Remove the Left Side Cover (page 8-18).
6. Remove the Rear Cover (page 8-20).
7. Remove the Fan (page 8-119).
8. Remove two circled screws at the bottom of the IP Board Cage.
9. Unplug the cables at P10 and P11 on the MCU Board.
10. Open the cage cover and disconnect P401 and P29 from the IP Board. Pull the
harnesses through the hole in the side of the cage.
11. Remove three circled screws at the top of the IP Board Cage (one screw is
behind the Fan).
Note
Loosening or removing the screw that holds the Fan Duct to the IP Board
cage can ease removal. Complete removal of the Fan Duct is unnecessary.
12. Swing the cage out from the bottom and lift up enough to free the hook at the
top.
s6500-328
P/J10
P/J11
http://www.manuals4you.com

Xerox Phaser 6500 Specifications

General

Monthly Duty Cycle	Up to 40, 000 pages
Duplex Printing	Manual
Print Technology	Laser
Maximum Print Resolution	600 x 600 x 4 dpi
First Page Out Time	As fast as 12 seconds
Connectivity	USB 2.0, Ethernet
Paper Capacity	250 sheets + 1 sheet bypass tray
Supported Operating Systems	Windows, Mac OS, Linux
Print Speed	Up to 24 ppm (color) / Up to 24 ppm (black)