Phaser 6500/WorkCentre 6505 Service Manual Xerox Internal Use Only 8-139
Service Parts Disassembly
SFP EEPROM Board
SFP PL8.2.16 (PWBA EEPROM [XPRO])
1. Remove Tray 1.
2. Open the Front Cover.
3. Remove the Rear Tray Cover (page 8-19).
4. Remove the Left Side Cover (page 8-18).
5. Remove the Rear Cover (page 8-20).
6. Remove the IP Board Cage (page 8-140).
7. Remove the MCU Board (page 8-138).
If a short Phillips-head screwdriver is unavailable to perform the following
step, remove the Laser Unit (page 8-86) to provide access.
8. Using a short Phillips-head screwdriver, remove the screw (silver, 6mm) that
secures the EEPROM Board to the chassis.
9. Disconnect P/J144 to remove the EEPROM Board.
To Next Page
Loading...
