Phaser 6500/WorkCentre 6505 Service Manual Xerox Internal Use Only 4-15
General Troubleshooting
NVM Settings Edits, saves, loads, and prints NVM information.
Edit NVM
■ Ad0000=00000000*
■ Please wait
Displays current NVM values. Use this
function to edit NVM information.
Not recommended for field use.
Caution: Change NVM values only
when directed to do so by a
troubleshooting procedure.
Save NVM to
ESS
■ Save NVM to ESS OK?
■ Processing
■ Saved
■ Please wait
Saves MCU NVM to the IP Board
when replacing MCU Board.
Load NVM
from ESS
■ Load NVM from ESS
OK?
■ Processing
■ Loaded
■ Please wait
Loads MCU NVM from the IP Board
following replacement of MCU Board.
Initialize Slave
■ OK?
■ Processing
■ Initialized
■ Please wait
Initializes slave. Not recommended
for field use.
Print Info Provides printer configurations and settings information.
Info Page
■ Ready
■ Processing
Prints version information. The
Configuration Page contains:
■ Engine unit information
■ Standard Tray
■ Optional Tray (displaying version)
■ Optional Duplex Unit (displaying
version)
■ Engine ROM Revision No.
■ MCU NVM Revision No.
Print Settings
■ Ready
■ Processing
Prints the configured settings.
■ Serial No.
■ HexDump On/Off Information
■ Tone Cor rectio n On/Off
Information
■ Color Print Count
■ B/W Print Count
■ Total Prin t Co unt
■ Color Backup Count
■ B/W Backup Count
■ Total Backup Count
■ Color Error Count
■ B/W Error Count
Installation Provides printer installation information.
Serial No.
■ PPPRSSSSS
or
■ MMMSSSSSSc
Displays the printer Serial Number.
See “Serial Number Format” on
page 9-2. This value is read-only.
Hex Dump
■ OFF *
■ ON
Sets HexDump On/Off. Used to
analyze received data in case of an
error. Setting Hex Dump to On
enables printing of received data via
Print Info > Info Page.
Test Control Panel Display Test Description
To Next Page
Loading...
Need help?
General