Phaser 6500/WorkCentre 6505 Service Manual Xerox Internal Use Only 4-55
General Troubleshooting
Counter Clear
(ADF)
Counter Clear (ADF)
■ Ready
■ Processing
■ Complete
Use to clear the ADF counter.
Parameter Parameter These functions read and write
parameters stored on the Image
Processor Board. Run this to configure
Scanner values manually.
Continue Illegal
■ Clear - delete data
■ Transmit - contents of
memory.
Specifies how to handle the
document data when the
transmission queue overflows
memory.
Thresh Memory
RX (%)
Sets the percentage of memory
reserved when data is received. When
the remaining memory amount falls
below this threshold, data reception is
denied. Values range from 0 to 100.
The smaller the value, the larger data
storage capacity becomes.
Thresh
Immediate (%)
Sets the remaining memory threshold
that triggers immediate output.
Immediate output refers to an
automatic image output to
accommodate incoming data that
exceeds memory capacity.
Values range from 0 to 99. The larger
the value, the sooner the immediate
output is initiated.
Thresh Memory
TX (%)
Sets the percentage of memory
reserved when data is sent. Values
range from 0 to 100. The smaller the
value, the greater the available
memory for scanned documents.
Thresh GC (%) Sets the remaining memory amount
in the Flash file system for image data
storage that triggers garbage
collection.
Page Margin 1
(mm)
Sets the page margin that allows a
larger-than-standard size document
to be handled as a standard size
document. The document is reduced
to the standard size by the set value.
Values range from 0 to 127. When the
value is 10, the margin is 10 mm.
Valid when the Discard Size setting in
Fax Setting is “Off”
Test Control Panel Display Test Description
To Next Page
Loading...
Need help?
General
