Phaser 6500/WorkCentre 6505 Service Manual Xerox Internal Use Only 8-11
Service Parts Disassembly
If a new Fuser is installed:
6. Reset the Fuser counter.
a. Power on the printer and allow it to reach Ready.
b. Press the Menu button (SFP) or System menu button (MFP).
c. Select Admin Menu > Maintenance (Mode) > Reset Fuser.
d. Click OK, then OK again at the Are you sure? prompt.
7. If the Fuser being replaced is at end of life, it is highly recommended
that the Feed Roller and Separator Holder also be replaced.
To Next Page
Loading...
