Xerox WorkCentre 3615 Service Manual

Troubleshooting
Phaser 3610, WorkCentre 3615 Service Manual 2-43
116-719
<XPIF Parameter Cancelled>
Cause:
Due to conflict among multiple print instructions,
print instructions are ignored.
FIP 1. 320
116-721
Memory Full
Press Ok Button
Error 116-721
Press Ok Button
<Collate Full>
Cause:
Unable to collate due to insufficient memory.
FIP 1. 321
117-321
Controller Error
Power Off/On
Error 117-321
Power Off/On
<Device Memory Error >
Cause:
SD CARD Type Invalid.
FIP 1. 327
117-338
Memory Detected
Power Off/On
<Enable Device Memory Error >
Cause:
Invalid, although SD CARD was detected.
FIP 1. 327
118-311
Google Cloud Print
Software Error
Error 118-311
Power Off/On
<Google Cloud Print Software Error>
Cause:
A critical internal error has occurred.
FIP 1. 336
142-700
Over Heating
Run Half-speed
<IOT Over Heat Forced Half Speed>
Cause:
Half-speed operation was forced due to abnor-
mally high temperature inside the IOT.
FIP 1. 385
193-700
Non-Xerox Toner
<Custom Toner Mode>
Cause:
The printer is in custom toner mode.
FIP 1. 386
Status
Code
(3610)
LCD Message Name/Description of Error FIP

Xerox WorkCentre 3615 Specifications

General

Print Technology	Laser
Print Resolution	Up to 1200 x 1200 dpi
Fax	Yes
Duplex Printing	Yes
Functions	Print, Copy, Scan, Fax
Processor	533 MHz
Memory (Standard)	256 MB
Paper Output	250 sheets
Fax Speed	33.6 kbps
Print Speed	47 ppm
Scan Resolution	600 x 600 dpi
Automatic Document Feeder	50 sheets
Connectivity	Ethernet
First Page Out Time (Copy)	8.5 seconds
Paper Capacity	250 sheets
Network Connectivity	Ethernet
Operating System Compatibility	Windows, Mac, Linux