Xerox WorkCentre 3615 - Page 164

Troubleshooting
Phaser 3610, WorkCentre 3615 Service Manual2-106
071-920 -
<Waiting to Print Side 2 Load Printed
Pages into the NNN>
Cause:
Waiting for side 2 to be set for manual
duplex print (Tray).
FIP 1. 274
071-921 -
<Manual Duplex Print>
Cause:
Waiting for Set key to be pressed after
setting side 2 for manual duplex print
(Tray).
FIP 1. 275
072-100 -
<IOT Tray2 Misfeed Jam>
Cause:
After the Tray 2 Feed Clutch turned
ON, the Tray 2 Path Sensor did not
turn ON within the specified time.
FIP 1. 276
072-101 -
<IOT Path 2 SNS On Jam>
Cause:
The Tray 2 Path Sensor did not turn
ON within the specified time after the
Tray 3 Path Sensor turned ON.
FIP 1. 277
072-102 -
<IOT Option Regi On Jam>
Cause:
After the Tray 2 Path Sensor turned
ON, the Regi. Sensor did not turn ON
within the specified time.
FIP 1. 278
072-211
Tray 2 Error 072-211
Power Off/On the Printer.
If this failure occurs again,
please contact customer sup-
port.
Code:xxxxxxxxh
<Feeder 2 Error>
Cause:
IOT Option Feeder2 Failure.
FIP 1. 279
073-100 -
<IOT Tray 3 Misfeed Jam>
Cause:
After the Tray 3 Feed Clutch turned
ON, the Tray 3 Path Sensor did not
turn ON within the specified time.
FIP 1. 276
Status
Code
(3615)
LCD Display Name/Description of Error FIP