Xerox WorkCentre 3615 Service Manual

Specifications
Phaser 3610, WorkCentre 3615 Service Manual8-10
Machine Functions
Resolution
Line Density in Fast Scan Direction
• 600 dots /25.4mm
• 1200 dots /25.4mm
Line Density in Slow Scan Direction
• 600 dots /25.4mm fixed
• 1200 dots /25.4mm fixed
Operation Mode
Power-off Status
The power switch is off and no power is supplied. The machine does not operate.
Ready (Standby) Mode
This mode is called as "Energy Saving: Step 1" for BAM (Blue Angel Mark) standard.
When the system starts up by power-on, it shifts from the power-off status to the Standby mode.
After pressing "Power Saver button" on the operator panel, the machine enters the Sleep Mode to save
more power consumption.
(for 3615) At this point, the provided functions (copying, FAX sending, network scanning) become
available via the operator panel. FAX receiving, printing, Direct FAX, and local scanning also become
available.
Running Mode
There are the Print mode, (3615) Scan mode, and FAX communication mode in which the IOT, IIT, and
FAX communication operate respectively.
Print Mode
In this mode, the IOT is operating for printing, (3615) copying, FAX received printing, and report
printing.
Scan Mode (3615)
In this mode, the IIT is operating for copy scanning, local scanning, network scanning, and FAX
scanning.
FAX Communication Mode (3615)
In this mode, FAX sending/receiving is in progress.

Xerox WorkCentre 3615 Specifications

General

Print Technology	Laser
Print Resolution	Up to 1200 x 1200 dpi
Fax	Yes
Duplex Printing	Yes
Functions	Print, Copy, Scan, Fax
Processor	533 MHz
Memory (Standard)	256 MB
Paper Output	250 sheets
Fax Speed	33.6 kbps
Print Speed	47 ppm
Scan Resolution	600 x 600 dpi
Automatic Document Feeder	50 sheets
Connectivity	Ethernet
First Page Out Time (Copy)	8.5 seconds
Paper Capacity	250 sheets
Network Connectivity	Ethernet
Operating System Compatibility	Windows, Mac, Linux