Specifications
Phaser 3610, WorkCentre 3615 Service Manual 8-11
Sleep Mode
This mode is called as "Energy Saving: Step 2" for BAM(Blue Angel Mark) standard.
When no job is executed for a certain period of time, the machine enters this mode to reduce the
standby electricity consumption.
The shift time from the Standby mode to Sleep mode can be changed from the operator panel (Setting
range: 1-60 min).
The factory default is 1 min.
The conditions that Sleep mode to Ready mode:
• Pressing "Energy Saver button" on the operator panel.
• Receiving a print job.
• Report printing directions from CWIS.
• (3615) Receiving a FAX Job.
• (3615) Receiving a direct FAX job.
• (3615) Start sending or polling data at the communication, if start time specified by the
operator.
Deep Sleep Mode
This mode is called as "Energy Saving: Step 3" for BAM(Blue Angel Mark) standard.
After the Sleep mode has continued for a certain period of time, the machine enters the Deep Sleep
Mode to save more power consumption.
The shift time from the Sleep mode to the Deep Sleep mode can be changed from the operator panel.
There is not defined Deep Sleep Mode and its menu.The shift time from the Sleep mode to the Deep
Sleep mode is fixed for 1min.
The Deep Sleep mode is cancelled by:
• Pressing Energy Saver button on the operator panel
• Receiving a print job
• Indicate Report Print from CWIS
• Start sending or polling data at a communication start time specified by the operator
• (3615) Receiving a FAX Job.
• (3615) Receiving a direct FAX job.
To Next Page
Loading...
Need help?
General
