998 CHAPTER 59: FTP&TFTP CONFIGURATION COMMANDS
undo passive
View
FTP Client view
Parameter
None
Description
Use the passive command to configure the data transmission mode as passive
mode.
Use the undo passive command to configure the data transmission mode as
active mode.
By default, the data transmission mode is passive mode
Example
# Set the data transmission to passive mode.
<SW8800> ftp
[ftp] passive
put Syntax
put localfile [ remotefile ]
View
FTP Client view
Parameter
localfile: Local file name.
remotefile: File name on the remote FTP Server.
Description
Use the put command to upload a local file to the remote FTP Server.
If the user does not specify the filename on the remote server, the system will
consider it the same as the local file name by default.
Example
# Upload the local file temp.c to the remote FTP Server and saves it as temp1.c.
<SW8800> ftp
[ftp] put temp.c temp1.c
pwd Syntax
pwd
View
FTP Client view
To Next Page
Loading...
