MBGP Multicast Extension Configuration Commands 657
undo debugging bgp mp-update
View
User view
Parameter
receive: Debugs the MBGP Update messages received.
send: Debugs the MBGP Update messages sent.
verbose: Debugs detailed information.
Description
Use the debugging bgp mp-update command to enable to debug MBGP
Update messages.
Use the undo debugging bgp mp-update command to disable the debugging.
By default, the debugging function is disabled.
Example
# Enable MBGP Update message debugging.
<SW8800> debugging bgp mp-update
default local-preference Syntax
default local-preference value
undo default local-preference
View
IPv4 multicast sub-address family view
Parameter
value: Default local precedence you configured, in the range of 0 to 4294967295.
By default, it is 100. The greatest value corresponds to the highest precedence
level.
Description
Use the default local-preference command to configure the default local
precedence.
Use the undo default local-preference command to restore the default value.
You can affect BGP route selection by configuring different local precedence
values.
Example
# Configure the default local precedence value as 180.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] bgp 100
To Next Page
Loading...
