QoS Commands 271
[3Com-Ethernet5/1/2] traffic-redirect inbound link-group 4000
interface ethernet5/1/1 4094 l3-vpn
# Configure traffic redirection on a service processor card for packets that match
the permit rules in ACL 3000.
1 Redirect the packets of VLAN4 that match the permit rules in ACL 3000 to a
service processor card in Ethernet port view.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800]interface e thernet5/1/2
[3Com-Ethernet5/1/2] traffic-redirect inbound ip-group 3000 slot 2 4
2 Redirect the packets that are distributed to the service processor card to the next
hop 202.119.85.1 and 202.119.95.1 in VLAN view.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] vlan 4
[3Com-vlan4] traffic-redirect inbound ip-group 3000 next-hop 202.119
.85.1
202.119.95.1 slot 2
traffic-shape Syntax
traffic-shape [ queue queue-id ] max-rate burst-size
undo traffic-shape [ queue queue-id ]
View
Ethernet port view, port group view
Parameter
queue queue-id: Specifies queue ID, in the range of 0 to 7.
max-rate: Maximum traffic rate in Kbps of the port.
burst-size: Burst size in KB. Its value should be the integer of 4.
Description
Use the traffic-shape command to enable traffic shaping.
Use the undo traffic-shape command to cancel traffic shaping.
The switch supports both shaping traffic based on port (shaping all traffic at the
port) and shaping the traffic in a specified queue at the port. You can achieve the
former mode by specifying no queue ID or the latter mode by specifying queue ID.
Example
# Shape the traffic in the outbound queue 2 at the port: maximum rate 500 Kbps,
burst size 12 Kbytes.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
To Next Page
Loading...
