LDP Configuration Commands 723
preference-value: Specifies preference value, ranging from 1 to 255, By default it is
60.
public: Configures a route as public network route.
reject: Configures a route as unreachable.
blackhole: Configures a route as blackhole.
Description
Use the ip route-static vpn-instance command to configure a static route by
specifying an interface of a private network as an egress interface.
Use the undo ip route-static vpn-instance command to delete the
configuration of this static route.
Example
# Configure a static route with destination address 100.1.1.1 and next hop
address 1.1.1.2.
[SW8800] ip route-static vpn-instance vpn1 100.1.1.1 16 vpn-instance
vpn1 1.1.1.2
ip vpn-instance Syntax
ip vpn-instance vpn-instance-name
undo ip vpn-instance vpn-instance-name
View
System view
Parameter
vpn-instance-name: Name assigned to VPN-instance.
Description
Use the ip vpn-instance command to create a VPN instance and enter VPN
instance view.
Use the undo ip vpn-instance command to delete the specified VPN instance.
By default, VPN-instance is not defined. Neither input nor output list is associated
with VPN-instance. No Route-map is associated with VPN-instance.
Use the ip vpn-instance command to create a VPN-instance named vpn-name.
Example
# Create the VPN instance VPN 1.
[SW8800] ip vpn-instance vpn1
[3Com-vpn-vpn1]
To Next Page
Loading...
