3Com 8807 - Display Poe Interface

50
POE CONFIGURATION COMMANDS
PoE Configuration
Commands
display poe interface Syntax
display poe interface [ interface-type interface-num ]
View
Any view
Parameter
interface-type interface-num: Port type and port number; refer to Command
Manual - Port for details.
Description
Use the display poe interface interface-type interface-num command to display
the PoE status of a specific port on the switch.
Use the display poe interface command without any option to display the PoE
status of all the PoE-capable ports on the switch.
Example
# Display the PoE status of the port GigabitEthernet3/1/1.
<SW8800> display poe interface GigabitEthernet3/1/1
Port power status :delivering
Port power mode :signal
Port PD class :2
port power priority :high
Port max power :16800 mW
Port current power :552 mW
Port remaining power :16248 mW
Port average power :717 mW
Port peak power :1196 mW
Port current :13 mA
Port voltage :53.7 V