882 CHAPTER 50: POE CONFIGURATION COMMANDS
View
Any view
Parameter
slotnum: Slot number of a PoE card
Description
Use the display poe slot slotnum command to display the information of a PoE
card in the switch.
Example
# Display the information of the PoE card in slot 8 of the switch.
[SW8800] display poe slot 8
PSE Information of slot 8:
Power Current Value :33 W
Power Remaining Value :772 W
Power Max Value :806 W
Power Peak Value :34 W
Power Average Value :33 W
Software Version :290
Hardware Version :000
poe enable Syntax
poe enable
undo poe enable
View
Ethernet port view
Parameter
None
Description
Use the poe enable command to enable the PoE feature on a port.
Use the undo poe enable command to disable the PoE feature on a port.
By default, PoE is disabled on port.
Example
# Enable PoE on current port.
[3Com-GigabitEthernet3/1/1] poe enable
# Disable PoE on current port.
[3Com-GigabitEthernet3/1/1] undo poe enable
poe enable slot Syntax
poe enable slot slot-num
To Next Page
Loading...
