3Com 8807 - Static-Lsp Ingress

688 CHAPTER 39: MPLS BASIC CONFIGURATION COMMANDS
Parameter
lsp-name: LSP name
interface-type Interface-number: Interface type, interface number.
in-label-value: Value of inbound label, ranging 3 (implicit empty label) and from 16
to 1023.
Description
Use the static-lsp egress command to configure a static LSP for an egress LSR.
Use the undo static-lsp egress command to delete an LSP for an egress LSR.
Related command: static-lsp ingress, static-lsp transit and debugging mpls.
Example
# Configure a static LSP named bj-sh on the egress LSR.
<SW8800> system-view
[3Com-mpls] static-lsp egress bj-sh incoming-interface vlan-
interface 201 in-label 233
static-lsp ingress Syntax
static-lsp ingress lsp-name { destination dest-addr { addr-mask | mask-length } |
l2vpn } nexthop next-hop-addr } } out-label out-label-value
undo static-lsp ingress lsp-name
View
MPLS view
Parameter
lsp-name: LSP name
dest-addr: Destination IP address.
addr-mask: Destination IP address mask.
mask-length: Mask length of destination IP address
next-hop-addr: Next-hop address.
out-label-value: Value of outbound label, ranging 3 (implicit empty label) and from
16 to 1023.
Description
Use the static-lsp ingress command to configure a static LSP for an ingress LSR.
Use the undo static-lsp ingress command to delete an LSP for an ingress LSR.
Related command: static-lsp egress, static-lsp transit and debugging mpls.