3Com 8807 - Apply Local-Preference; Apply Origin

IP Routing Policy Configuration Commands 551
Description
Use the apply isis command to configure to apply the level of a matched route to
be imported to Level-1, Level-2 or Level-1-2.
Use the undo apply isis command to cancel the Apply sub-statement.
By default, no apply clause is defined.
Related command: if-match interface, if-match acl, if-match ip-prefix,
if-match ip next-hop, if-match cost, if-match tag, route-policy, apply ip
next-hop, apply cost, apply origin, apply tag.
Example
# Define an apply clause, setting to import the route to a level-2 area.
[3Com-route-policy] apply isis level-2
apply local-preference Syntax
apply local-preference local-preference-value
undo apply local-preference
View
Route policy view
Parameter
local-preference: Newly set local preference.
Description
Use the apply local-preference command to configure to apply the local
preference of route information.
Use the undo apply local-preference command to cancel the Apply
sub-statement.
Related command: if-match interface, if-match acl, if-match ip-prefix,
if-match ip next-hop, if-match cost, if-match tag, route-policy, apply ip
next-hop, apply local-preference, apply origin, apply tag.
Example
# Define an Apply sub-statement. Apply the local preference level of route
information as 130 when this Apply sub-statement is used for setting route
information attribute. .
[3Com-route-policy] apply local-preference 130
apply origin Syntax
apply origin { igp | egp as-number | incomplete }
undo apply origin