3Com 8807 - Display Dhcp Server Free-Ip; Display Dhcp Server Ip-In-Use

DHCP Server Configuration Commands 837
display dhcp server
free-ip
Syntax
display dhcp server free-ip
View
Any view
Parameter
None
Description
Use the display dhcp server free-ip command to display the ranges of available
(unassigned) IP addresses in DHCP address pools.
Example
# Display the ranges of available (unassigned) IP addresses in DHCP address pools.
<SW8800> display dhcp server free-ip
IP Range from 1.0.0.0 to 2.2.2.1
IP Range from 2.2.2.3 to 2.255.255.255
IP Range from 4.0.0.0 to 4.255.255.255
IP Range from 5.5.5.0 to 5.5.5.0
IP Range from 5.5.5.2 to 5.5.5.255
display dhcp server
ip-in-use
Syntax
display dhcp server ip-in-use { ip ip-address | pool [ pool-name ] | interface [
vlan-interface vlan-id ] | all }
View
Any view
Parameter
ip ip-address: Specifies an IP address.
pool [ pool-name ]: Specifies a global address pool. If you do not input a
pool-name, all global address pools are included.
interface [ vlan-interface vlan-id ]: Specifies a VLAN interface address pool. If
you do not input a vlan-id, all VLAN interface address pools are included.
all: Specifies all DHCP address pools.
Description
Use the display dhcp server ip-in-use command to display information about IP
address binding in DHCP address pool(s).
Related command: reset dhcp server ip-in-use.
Example
# Display information about IP address binding in all DHCP address pools.
<SW8800> display dhcp server ip-in-use all
Global pool:
IP address Hardware address Lease expiration Type