3Com 8807 - Network; Peer Advertise-Community

666 CHAPTER 38: MBGP MULTICAST EXTENSION CONFIGURATION COMMANDS
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] bgp 100
[3Com-bgp] ipv4-family multicast
[3Com-bgp-af-mul]
network Syntax
network ip-address [ address-mask ] [ route-policy route-policy-name ]
undo network ip-address [ address-mask ] [ route-policy route-policy-name ]
View
IPv4 multicast sub-address family view
Parameter
ip-address: Network address that BGP advertises.
address-mask: Mask of the network address.
route-policy policy-name: Route-policy applied to the routes advertised.
Description
Use the network command to configure the network addresses to be sent by the
local MBGP.
Use the undo network command to remove the configuration.
By default, the local MBGP does not send any route.
Example
# Advertise routes to network segment 10.0.0.0/16.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] bgp 100
[3Com-bgp] ipv4-family multicast
[3Com-bgp-af-mul] network 10.0.0.1 255.255.0.0
peer
advertise-community
Syntax
peer group-name advertise-community
undo peer group-name advertise-community
View
IPv4 multicast sub-address family view
Parameter
group-name: Name of the peer group.
Description
Use the peer advertise-community command to set to send community
attributes to a peer group.