772 CHAPTER 41: MPLS VLL CONFIGURATION COMMANDS
peer enable Syntax
peer { group-name | peer-address } enable
undo peer { group-name | peer-address } enable
View
L2VPN address family view
Parameter
group-name: Name of the peer group. This argument specifies the entire peer
group.
peer-address: IP address of a peer. This argument specifies a specific peer.
Description
Use the peer enable command to activate a specified peer or peer group in
L2VPN address family view.
Use the undo peer enable command to deactivate a specified peer or peer group
in L2VPN address family view.
By default, the unicast peers or peer groups of IPv4 address family are active.
Whereas other types of peers or peer groups are inactive.
Example
# Activate peer 192 or peer group 192 in L2VPN address family view.
[3Com-bgp] group 192 internal
[3Com-bgp] peer 192.1.1.1 group 192
[3Com-bgp] l2vpn-family
[3Com-bgp-af-l2vpn] peer 192
enable
To Next Page
Loading...
