3Com 8807 - Igmp Robust-Count; Igmp-Report Enhance Enable

612 CHAPTER 35: IGMP CONFIGURATION COMMANDS
Example
# Set the maximum response time carried in host-query message to 8 seconds.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800]interface vlan-interface 10
[3Com-Vlan-interface10] igmp max-response-time 8
igmp-report enhance
enable
Syntax
igmp-report enhance enable
igmp-report enhance disable
View
System view
Parameter
None
Description
Use the igmp-report enhance enable command to enable the compatibility
control function of the switch.
Use the igmp-report enhance disable command to disable the function.
With the compatibility control function enabled, the switch processes the protocol
packet with the destination IP address 224.0.0.1 among IGMP Report packets.
Otherwise, the switch drops this kind of packets.
By default, the compatibility control function of the switch is disabled.
This command is often executed after IGMP or IGMP Spooning protocol is enabled
in the system.
Related command: igmp { enable | disable } and igmp-snooping { enable |
disable }
Example
# Enable the compatibility control function of the switch.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] igmp-report enhance enable
igmp robust-count Syntax
igmp robust-count robust-value
undo igmp robust-count
View
Interface view