422 CHAPTER 25: OSPF CONFIGURATION COMMANDS
View
Any view
Description
Use the display debugging ospf command to view the debugging states of
global OSPF and all processes.
Related command: debugging ospf.
Example
# Display the debugging states of global OSPF and all processes.
<SW8800> display debugging ospf
OSPF global debugging state:
OSPF SPF debugging is on
OSPF LSA debugging is on
OSPF process 100 debugging state:
OSPF SPF debugging is on
OSPF process 200 debugging state:
OSPF SPF debugging is on
OSPF LSA debugging is on
display ospf abr-asbr Syntax
display ospf [ process-id ] abr-asbr
View
Any view
Parameter
process-id: Process ID of OSPF. The command is applied to all current OSPF
processes if you do not specify a process ID.
Description
Use the display ospf abr-asbr command to view the information about the ABR
and ASBR of OSPF.
Example
# Display the information of the OSPF area border routers and autonomous system
border routers.
<SW8800> display ospf abr-asbr
OSPF Process 1 with Router ID 10.110.98.138
Routing Table to ABR and ASBR
I = Intra i = Inter A = ASBR B = ABR S = SumASBR
Destination Area Cost Nexthop Interface
IA 2.2.2.2 0.0.0.0 10 10.153.17.89 Vlan-interface1
Tabl e 54 Description of the fields of the display ospf abr-asbr command
Field Description
Destination Router ID of the ABR or ASBR
Area Area where the router is connected with ASBR
Cost The routing overhead value of the route
To Next Page
Loading...
