354 CHAPTER 21: AAA AND RADIUS/HWTACACS PROTOCOL CONFIGURATION COMMANDS
debugging hwtacacs Syntax
debugging hwtacacs { all | error | event | message | receive-packet |
send-packet }
undo debugging hwtacacs { all | error | event | message | receive-packet |
send-packet }
View
User view
Parameter
all: Enables all HWTACACS debugging.
error: Enables error debugging.
event: Enables event debugging.
message: Enables message debugging.
receive-packet: Enables incoming packet debugging.
send-packet: Enables outgoing packet debugging.
Description
Use the debugging hwtacacs command to enable HWTACACS debugging.
Use the undo debugging hwtacacs command to disable HWTACACS
debugging.
By default, HWTACACS debugging is disabled.
Example
# Enable the event debugging of HWTACACS.
<SW8800> debugging hwtacacs event
display hwtacacs Syntax
display hwtacacs [ hwtacacs-scheme-name]
View
Any view
Parameter
hwtacacs-scheme-name: Scheme name of the HWTACACS server, a string of 1 to
32 case-insensitive characters, excluding "?". If this argument is null,
configuration information of all HWTACACS schemes are displayed.
Description
Use the display hwtacacs command to view configuration information of one or
all HWTACACS schemes.
By default, configuration information of all HWTACACS schemes is displayed.
To Next Page
Loading...
