3Com 8807 - Source-Interface; Source-Ip

1082 CHAPTER 66: NQA CONFIGURATION COMMANDS
source-interface Syntax
source-interface { interface-type interface-number }
undo source-interface
View
NQA test group view
Parameter
interface-type: Type of interface.
interface-number: Number of interface.
Description
Use the source-interface command to configure the source interface for sending
test packet.
Use the undo source-interface command to disable the configured source
interface.
By default, no source interface for sending test packet is configured.
n
The source interface must be a Layer 3 interface. Otherwise, the system stops the
test for not finding the corresponding IP address. If a source IP address is
configured, no IP address of the source interface will be used. But the system still
checks whether the interface is a Layer 3 interface or not as the ordinary ping
operation does.
Example
# Configure the Vlan-interface 60 as the source interface for sending test packet.
<SW8800>system-view
System View: return to User View with Ctrl+Z.
[SW8800] nqa-agent enable
[SW8800] nqa administrator icmp
[3Com-administrator-icmp] source-interface Vlan-interface 60
source-ip Syntax
source-ip ip-address
undo source-ip
View
NQA test group view
Parameter
ip-address: Source IP address of the test.
Description
Use the source-ip command to configure the source IP address of the test.
Use the undo source-ip command to cancel the configured source IP address.