3Com 8807 - Display Msdp Sa-Count

640 CHAPTER 37: MSDP CONFIGURATION COMMANDS
autonomous-system-number: Autonomous system number. Displays (S, G) entries
from specified autonomous system.
Description
Use the display msdp sa-cache command to view (S, G) state learnt from MSDP
peer.
Only cache-sa-enable command is configured, can cache state be displayed.
Example
# Display the (S, G) state learned from MSDP peer.
<SW8800> display msdp sa-cache
MSDP Total Source-Active Cache - 5 entries
(Source, Group) Origin RP Pro AS Uptime Expires
(10.10.1.2, 225.1.1.1) 10.10.10.10 BGP 100 00:00:10 00:05:50
(10.10.1.3, 225.1.1.1) 10.10.10.10 BGP 100 00:00:11 00:05:49
(10.10.1.2, 225.1.1.2) 10.10.10.10 BGP 100 00:00:11 00:05:49
(10.10.2.1, 225.1.1.2) 10.10.10.10 BGP 100 00:00:11 00:05:49
(10.10.1.2, 225.1.2.2) 10.10.10.10 BGP 100 00:00:11 00:05:49
MSDP matched 5 entries
display msdp sa-count Syntax
display msdp sa-count [ as-number ]
View
Any view
Parameter
as-number: Number of sources and groups from the specified autonomous
system.
Description
Use the display msdp sa-count command to view the number of sources and
groups in MSDP cache.
The cache-sa-enable command must be configured before the configuration of
this command.
Example
# view the number of sources and groups in MSDP cache.
<SW8800> display msdp sa-count
Number of cached Source-Active entries, counted by Peer
Peer’s Address Number of SA
10.10.10.10 5
Number of source and group, counted by AS
AS Number of source Number of group
? 3 3
Total Source-Active entries: 5