3Com 8807 - Debugging Pim Common; Debugging Pim DM

PIM Configuration Commands 621
[3Com-pim] crp-policy 3000
[3Com-pim] quit
[SW8800] acl number 3000
[3Com-acl-adv-3000] rule 0 permit source 1.1.1.1 0 destination 225.1
.0.0 0.0.255.255
debugging pim common Syntax
debugging pim common { all | event | packet | timer }
undo debugging pim common { all | event | packet | timer }
View
User view
Parameter
all: All the common debugging information of PIM.
event: Debugging information of common PIM event.
packet: Debugging information of PIM hello packet.
timer: Debugging information of common PIM timer.
Description
Use the debugging pim common command to enable common PIM debugging
functions.
Use the undo debugging pim common command to disable the debugging
functions.
By default, common PIM debugging functions are disabled.
Example
# Enable all common PIM debugging functions
<SW8800> debugging pim common all
debugging pim dm Syntax
debugging pim dm { alert | all | mrt | timer | warning | { recv | send } { all |
assert | graft | graft-ack | join | prune } }
undo debugging pim dm { alert | all | mrt | timer | warning | { recv | send } {
all | assert | graft | graft-ack | join | prune } }
View
User view
Parameter
alert: Interoperation event debugging information of PIM-DM
all: All the debugging information of PIM-DM.
mrt: Debugging information of PIM-DM multicast routing table.