3Com 8807 - Timeout

NQA Configuration Commands 1085
Example
# Specify the test type as icmp.
<SW8800>system-view
System View: return to User View with Ctrl+Z.
[SW8800] nqa-agent enable
[SW8800] nqa administrator icmp
[3Com-administrator-icmp] test-type icmp
timeout Syntax
timeout time
undo timeout
View
NQA test group view
Parameter
time: Timeout time. Its unit is second.
Description
Use the timeout command to configure the timeout time of the test operation.
Use the undo timeout command to restore the timeout time to the default value.
By default, the timeout time of test operation is 3 seconds
Example
# Set the timeout time to 10 seconds.
<SW8800>system-view
System View: return to User View with Ctrl+Z.
[SW8800] nqa-agent enable
[SW8800] nqa administrator icmp
[3Com-administrator-icmp] timeout 10
tos Syntax
tos value
undo tos
View
NQA test group view
Parameter
value: TOS (type of service) value in the NQA test packet header.
Description
Use the tos command to configure the TOS value in the NQA test packet header.
Use the undo tos command to restore the TOS value in the NQA test packet
header to the default value.