3Com 8807 - Undo Mac-Address Vsi

VPLS Configuration Commands 787
Parameter
None
Description
Use the shutdown command to shut down the service of the VSI. When the
service of the VSI is shut down, the system does not process any traffic for this VSI.
Use the undo shutdown command to restore the service for the VSI.
Example
# Shut down the service of VSI 3Com.
<SW8800> system-view
[SW8800] vsi 3com static
[3Com-vsi-3Com] shutdown
# Restore the service of VSI 3Com.
<SW8800> system-view
[SW8800] vsi 3com static
3Com-vsi-3Com] undo shutdown
undo mac-address vsi Syntax
undo mac-address vsi [ vsi-name [ peer peer-ip | vlan-interface vlan-id ] ] [
static | dynamic ]
View
System view
Parameter
vsi-name: VSI name.
vlan-id: VLAN interface ID.
static: Specifies static MAC addresses.
dynamic: Specifies dynamic MAC addresses.
Description
Use the undo mac-address vsi command to batch remove VPLS MAC addresses.
Related command: display mac-address vsi and reset mac-address vsi.
Example
# Remove all dynamic VPLS MAC addresses on Vlan-interface10 in VSI VPN1.
<SW8800> system-view
[SW8800] undo mac-address vsi vpn1 vlan-interface 10 dynamic
vsi Syntax
vsi vsi-name [ static ]
undo vsi vsi-name