3Com 8807 - Display Bgp L2 Vpn; Display Mpls L2 Vpn

768 CHAPTER 41: MPLS VLL CONFIGURATION COMMANDS
You need to configure the route distinguisher (RD) for the MPLS L2VPN before
creating a CE connection.
Related command: mpls l2vpn encapsulation.
Example
# Create a CE connection.
[SW8800] mpls l2vpn vpna
[3Com-l2vpn-vpna] ce ce-a id 1 range 4
[3Com-l2vpn-vpna-ce-ce-a] connection interface vlan-interface 201
display bgp l2vpn Syntax
display bgp l2vpn { all | peer | route-distinguisher ASN }
View
Any view
Parameter
all: Displays all the L2VPN information about the address family.
peer: Displays the information about a specified BGP Peer in brief.
route-distinguisher: Displays the information about a specified VPN RD.
ASN: Route identifier.
Description
Use the display bgp l2vpn command to display the information about Kompella
L2VPN.
Example
# Display all the L2VPN information.
<SW8800> display bgp l2vpn all
BGP local router ID is 172.16.1.5 , Origin codes: i - IGP, e - EGP, ? -
incomplete
bgp.l2vpn: 3 destinations
CE ID Label Offset Label Base nexthop pref as-path
Route Distinguisher: 100:1
2 1 800000 1.1.1.1 100 I 200 600
3 1 500000 1.1.1.1 100 I 200 600
Route Distinguisher: 100:2
1 1 700000 1.1.1.1 100 I 200 600
display mpls l2vpn Syntax
display mpls l2vpn [ vsi-name [ local-ce | remote-ce ] | connection [ vsi-name [
down | remote-ce | up | verbose ] | brief | interface Vlan-interface vlan-id ] |
forwarding-info { vc-label | interface interface-type } ]
View
Any view