3Com 8807 - Debugging Multicast Status-Forwarding; Display Mpm Forwarding-Table

Multicast Common Configuration Commands 585
Parameter
None
Description
Use the debugging multicast kernel-routing command to enable multicast
kernel routing debugging functions.
Use the undo debugging multicast kernel-routing command to disable the
debugging functions.
By default, the multicast kernel routing debugging is disabled.
Example
# Enable multicast kernel routing debugging functions.
<SW8800> debugging multicast kernel-routing
debugging multicast
status-forwarding
Syntax
debugging multicast status-forwarding
undo debugging multicast status-forwarding
View
User view
Parameter
None
Description
Use the debugging multicast status-forwarding command to enable multicast
forwarding status debugging functions.
Use the undo debugging multicast status-forwarding command to disable
the debugging functions.
By default, the multicast forwarding status debugging is disabled.
Example
# Enable multicast forwarding status debugging functions.
<SW8800> debugging multicast status-forwarding
display mpm
forwarding-table
Syntax
display mpm forwarding-table [ group-address | source-address ]
View
Any view
Parameter
group-address: Multicast group address, used to specify a multicast group,
ranging from 224.0.0.0 to 239.255.255.255.