302 CHAPTER 20: 802.1X CONFIGURATION COMMANDS
This command has effect on the interface specified by the parameter interface-list
when executed in system view. It has effect on all the interfaces when no interface
is specified. The parameter interface-list cannot be input when the command is
executed in Ethernet interface view and it has effect only on the current interface.
Related command: display dot1x.
Example
# Authenticate the supplicant based on the interface number on Ethernet 3/1/1.
[SW8800] dot1x port-method portbased interface ethernet 3/1/1
dot1x quiet-period Command
dot1x quiet-period
undo dot1x quiet-period
View
System view
Parameter
None
Description
Use the dot1x quiet-period command to enable the Quiet-period timer.
Use the undo dot1x quiet-period command to disable this timer.
If an 802.1x user has not passed the authentication, the Authenticator will keep
quiet for a while (which is specified by quiet-period timer) before launching the
authentication again. During the quiet period, the Authenticator does not do
anything related to 802.1x authentication.
By default, Quiet-period timer is disabled.
Related command: display dot1x , dot1x timer quiet-period.
Example
# Enable quiet-period timer.
[SW8800] dot1x quiet-period
dot1x retry Syntax
dot1x retry max-retry-value
undo dot1x retry
View
System view
To Next Page
Loading...
