3Com 8807 - Info-Center Loghost Source; Info-Center Monitor Channel

Information Center Configuration Commands 1013
This command takes effect only after the system logging is enabled.
Related command: info-center enable, display info-center.
Example
# Configure to send log information to the UNIX workstation at 202.38.160.1.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] info-center loghost 202.38.160.1
info-center loghost
source
Syntax
info-center loghost source interface-type interface-number
undo info-center loghost source
View
System view
Parameter
interface-type interface-number: Layer 3 interface on the switch.
Description
Use the info-center loghost source command to specify source address of the
packets sent to loghost as the address of the interface specified by the
interface-name.
Use the undo info-center loghost source command to cancel the specified
source address of the packets sent to loghost.
Related command: info-center enable, display info-center.
Example
# Specify source address of the packets sent to loghost as the address of the VLAN
interface 1.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] info-center loghost source vlan-interface 1
info-center monitor
channel
Syntax
info-center monitor channel { channel-number | channel-name }
undo info-center monitor channel
View
System view
Parameter
channel-number: Channel number, ranging from 0 to 9, that is, the system has ten
channels.