766 CHAPTER 41: MPLS VLL CONFIGURATION COMMANDS
Interface: Vlan-interface1001State: down, Encapsulation: ethernet,
Service: VLL
VC-ID: 10001, VC State: down, Destination: 1.1.1.1
Group ID: Local 0, Remote 0, VC Label: Local 32771, Remote 0,
Tunnel Type: LSP, Tunnel Index: 23
mpls l2vc Syntax
mpls l2vc ip-address vc-id
undo mpls l2vc
View
VLAN interface view
Parameter
ip-address: IP address of LSR-ID on the peer PE.
vc-id: ID of the VC, ranging from 1 to 4,294,967,295.
Description
Use the mpls l2vc command to create a Martini MPLS L2VPN virtual connection.
Use the undo mpls l2vc command to remove a Martini MPLS L2VPN virtual
connection.
You need to enable MPLS L2VPN before using the command.
Related command: mpls l2vpn, display mpls l2vc.
Example
# Create a virtual connection with the ID of 23.
[3Com-Vlan-interface201] mpls l2vc 10.0.0.11 23
Kompella MPLS L2VPN
Configuration
Commands
ce Syntax
ce name [ id id [ range range | default-offset offset ]
undo ce name
View
MPLS L2VPN view
Parameter
name: Name of the CE, which must be unique in the current VPN of the PE. This
argument is 1 to 20 characters in length.
To Next Page
Loading...
