240 CHAPTER 17: QOS COMMANDS
Example
# Display parameter configuration of traffic rate limitation,.
<SW8800> display qos-interface traffic-limit
GigabitEthernet2/1/1: traffic-limit
Inbound:
Matches: Acl 2020 rule 0 running
Committed Information Rate: 1000 Kbps
Committed Burst Size: 1000 byte(s)
Excess Burst Size: 1000 byte(s)
Peak Information Rate: 0 Kbps
display qos-interface
traffic-priority
Syntax
display qos-interface [ interface-type interface-number ] traffic-priority
View
Any view
Parameter
interface-type interface-number: Port of the switch, for detailed description,
please refer to Command Manual - Port.
Description
Use the display qos-interface traffic-priority command to view traffic priority
configuration of a port, including the target ACL, priority type, priority values etc.
Related command: traffic-priority.
Example
# Display traffic priority marking configuration.
<SW8800> display qos-interface traffic-priority
GigabitEthernet2/1/1: traffic-priority
Inbound:
Matches: Acl 2021 rule 0 running
Priority action: remark-policed-service, dscp: 20
display qos-interface
traffic-redirect
Syntax
display qos-interface [ interface-type interface-number ] traffic-redirect
View
Any view
Parameter
interface-type interface-number: Port of the switch, for detailed description,
please refer to Command Manual - Port.
Description
Use the display qos-interface traffic-redirect command to view traffic
redirection configuration of a port, including the target ACL, target port etc.
Related command: traffic-redirect.
To Next Page
Loading...
