3Com 8807 - Nesting-Vpn; Network

LDP Configuration Commands 725
[SW8800] bgp 100
[3Com-bgp] ipv4-family vpn-instance abc
[3Com-bgp-af-vpn-instance]
# Enter VPNv4 sub-address family view.
[SW8800] bgp 100
[3Com-bgp] ipv4-family vpnv4 unicast
[3Com-bgp-af-vpn]
nesting-vpn Syntax
nesting-vpn
undo nesting-vpn
View
BGP-VPNv4 sub-address family view
Parameter
None
Description
Use the nesting-vpn command to enable the nested VPN function.
Use the undo nesting-vpn command to disable this function.
By default, the nested VPN function is disabled.
If VPNv4 route advertisement is needed for a CE connected to a PE, the nested
VPN function must be enabled on the PE.
Example
# Enable the nested VPN function.
[3Com-bgp-af-vpn] nesting-vpn
network Syntax
network ip-address [ address-mask ] [ route-policy policy-name ]
undo network ip-address [ address-mask ] [ route-policy policy-name ]
View
VPN-instance sub-address family view
Parameter
ip-address: Network address advertised by BGP in dotted decimal notation.
address-mask: Mask of the network address.
policy-name: Name of the routing policy applied to the advertised route.