3Com 8807 - Static-Lsp Egress; Snmp-Agent Trap Enable Lsp

MPLS Basic Configuration Commands 687
Parameter
None
Description
Use the snmp-agent trap enable ldp command to enable Trap function in MPLS
LDP creation.
Use the undo snmp-agent trap enable ldp command to disable Trap function in
MPLS LDP creation.
By default, Trap function is not enabled during MPLS LDP creation.
Example
# Enable the Trap function during MPLS LDP creation.
<SW8800> system-view
[SW8800] snmp-agent trap enable ldp
snmp-agent trap enable
lsp
Syntax
snmp-agent trap enable lsp
undo snmp-agent trap enable lsp
View
System view
Parameter
None
Description
Use the snmp-agent trap enable lsp command to enable Trap function in MPLS
LSP creation.
Use the undo snmp-agent trap enable lsp command to disable Trap function in
MPLS LSP creation.
By default, Trap function is disabled during MPLS LSP creation.
Example
# Enable the Trap function during MPLS LSP creation.
<SW8800> system-view
[SW8800] snmp-agent trap enable lsp
static-lsp egress Syntax
static-lsp egress lsp-name [ l2vpn ] incoming-interface interface-type
interface-number in-label in-label-value
undo static-lsp egress lsp-name
View
MPLS view