3Com 8807 - Display Dhcp Server Conflict

DHCP Server Configuration Commands 835
Parameter
ip-address: IP address to be bound statically. Note that the IP address must be a
valid IP address in the address pool of the current VLAN interface.
mac-address: MAC address for the IP address to be bound to.
Description
Use the dhcp server static-bind command to statically bind an IP address in the
address pool of the current VLAN interface to a MAC address.
Use the undo dhcp server static-bind command to remove a statically bound IP
address entry.
IP addresses in the address pool of a VLAN interface are not statically bound by
default.
VLAN interface address pool only supports one-to-one MAC-IP binding.
Example
# Statically bind the IP address 10.1.1.1 to the MAC address 0000-e03f-0305.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] interface vlan-interface 1
[3Com-Vlan-interface1] dhcp server static-bind ip-address 10.1.1.1 m
ac-address
0000-e03f-0305
display dhcp server
conflict
Syntax
display dhcp server conflict { all | ip ip-address }
View
Any view
Parameter
all: Specifies all IP addresses.
ip ip-address: Specifies an IP address.
Description
Use the display dhcp server conflict command to display the statistics about
DHCP address conflicts.
Related command: reset dhcp server conflict.
Example
# Display the statistics about DHCP address conflicts.
<SW8800> display dhcp server conflict all
Address Discover Time
10.110.1.2 Jan 11 2003 11:57: 7 PM